Vectric vcarve pro stepover software#
Vectric vcarve pro stepover plus#

This dimension can be changed by opening the Material Setup form. The height above the job at which it is safe to move the cutter at rapid / max feed rate. When this option is selected, VCarve Pro will calculate the boundary offset to ensure that the tool fully cuts the ends of profile, even if profile ends in vertical/steep edges. With a Boundary Offset value specified you can see the toolpath cuts over the edges. If you wanted to ensure the roughing had also been able to machine these areas then the value should be based on your Larger Area Clearance Tool size instead. For example if you are using a 0.25 inch (6mm) diameter ball-nose tool for the finish cut then you would specify a minimum of 0.15 inch or 3.6mm (= tool radius + 10%) to ensure the tool would be forced down the edges of your shape.

Vectric vcarve pro stepover plus#

As such if you want to ensure a vertical or very steep edge at your profile ends is machined you will need to specify a value which is at least the radius of your tool plus a small additional amount (say an additional 10% of the radius). The value entered for the Boundary Offset will force the tool past the ends by the specified amount. It may be desirable to extend this distance to either force the tool down the edge of the profile shape with vertical or steep edges or to ensure the toolpath has gone far enough past the edge to cleanly cutout the final shape with a profile toolpath. By default the center of the tool will go to the edge of the ends of the selected profile vector as its extruded along the drive rail. This option can be used to force the toolpath to cut past the edge of the part that is parallel to the drive curve vector. The toolpath should be run first on the machine:

Vectric vcarve pro stepover software#

When you use the option to Use Larger Area Clearance Tool, the software will calculate two toolpaths, the first will have in its name to differentiate the two, being the toolpath associated with the Use Larger Area Clearance Tooland the other, is the finish toolpath using the smaller tool. As documented above and below using this option with a flat shaped tool can also be very beneficial to the machining time and finish on cross section profile shapes with flat/horizontal regions. This should be used if the material is too deep and/or hard to cut directly with your selected finishing tool. It will use the tool parameters to generate multiple depth 2D pockets following the direction of the selected rail to clear away excess material. In effect the Larger Area Clearance Tool is similar to a 3D Z Level Roughing toolpath and would be cut first. If this option is selected, then two tools are used to cut the shape. Simple Rotary Modelling using 2D Toolpaths.Importing External Models in a Rotary Project.Save All Visible Toolpaths as a Template.

Import 3D Model into Single or Two Sided Job.Create Vector Boundary From Selected Components.Join / Close Vector with a Straight Line.Join / Close Vector with a Smooth Curve.